1988-2003 Ford Ranger with 5-Speed Manual Transmission Installation Instructions

Thank you for choosing the Hurst Billet/Plus Shifter for your Ford Ranger! This shifter features a high pivot ratio and is designed to reduce the throw approximately 30 % for shorter and quicker shifts, precisely balancing distance, effort, comfort, and control to give you the most satisfaction from a shifter. It is constructed of a CNC machined BILLET ALUMINUM mounting base and heat treated BILLET STEEL gear selector for ultimate strength and p…

2007 MITSUBISHI GALANT SERVICE MANUAL

This service manual is subdivided into various group Alphabetical Index . . . . . . . . . . . . . . categories. Each section contains diagnostic, NOTE: disassembly, repair, and installation procedures, For the information on all service manual along with complete specifications and tightening groups not listed above, please refer to references. Use of this manual will aid in properly Volume 2, 3 and 4. performing any service necessary to maintai…

2003 Ford Truck Ranger 4WD V6-4.0L Pinion Flange: Service and Repair Ford 8.8 Inch Ring Gear High Torque

Removal 1. Position the vehicle on a hoist. 2. NOTE: The rear wheels and brake drums Must be removed to prevent brake drag during drive pinion bearing preload adjustment. Remove the wheel and tire assembly.3. Remove the rear brake drums.4. Mark the driveshaft flange and pinion flange for correct alignment during installation.5. Remove the four driveshaft bolts.6. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion…

1987 Ford Ranger 2.3L Turbo Harness

Pre-installation Notes: • This system is designed to install a Ford 2.3 Turbo engine into a Ford Ranger or other similar Ford bodied vehicle. • This harness is designed to use a 1987-88 Turbo Coupe ECM (calibration code LA2 or LA3) UNLESS YOU HAVE SPECIFIED THE USE OF AN EARLIER MOTOR. We have supplied circuitry for an electric fan but a 1987-88 Turbo Coupe (calibration code: LA2, LA3 or similar) must be used to take advantage of those features….

2006-2010 Ford Focus Manual Transmission/Transaxle: Service and Repair Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.2. Remove the steering column shaft bolt. ^ To install, tighten to 28 Nm (21 ft. lbs.). 3. Remove the battery. For additional information, refer to Battery. Download Related Entry: transaxle for 2006 ford focus…