2000-2006 Ford F-650 Oil Pan Removal and Installation

SERVICE PROCEDURE Clean the oil pan off with a solvent to remove any dirt and oil. Using a 3″ angle grinder with a 36 grit disc, grind off all loose corrosion. Blow off with air. Wash the pan with soap and water and let dry. Brush the anti-corrosion coating on the oil pan. Allow coating to dry fully before operating the vehicle. Download…

2000 Ford Explorer Crankshaft Rear Oil Seal Removal and Istallation

Removal 1. Remove the flexplate or flywheel. For additional information, refer to Flexplate or Flywheel in this section. 2. NOTE: The crankshaft rear seal may have a metal speedy sleeve. This sleeve must be removed before attempting to remove the seal. If necessary, remove the speedy sleeve using two screwdrivers or small pry bars. 3. Using the special tool, remove the crankshaft rear oil seal. Installation 1. NOTE: Make sure the crankshaft rear…

1997 Ford F-150 Crankshaft Rear Seal with Retainer Plate Removal and Installation

Removal 1. Remove the oil pan (6675). For additional information, refer to Oil Pan—4×2 or Oil Pan—4×4 in this section. 2. Remove the flexplate or the flywheel (6375). For additional information, refer to Flexplate or Flywheel in this section. 3. Use the (A) Rear Crank Slinger Remover and the (B) Slide Hammer to remove the (C) rear oil seal slinger. 4. Use the (A) Rear Crankshaft Seal Remover and the (B) Slide Hammer to remove the (C) r…

2004 Ford F-150 Oil pan Removal and Installation

…With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-00. 2. If oil pump removal is necessary, remove the timing drive components. For additional information, refer to Timing Drive Components in this section. 3. Drain the engine oil. 4. If equipped, remove the skid plate. 5. Remove the bolts in sequence shown and remove the crossmember. 6. Remove the parts in the order indicated in the following il…

1986-2001 Ford TAURUS Oil pan Removal and Installation

ISSUE A service oil pan gasket and a new service oil pan gasket kit has been released for all 3.0L-2V “Vulcan” engines built from 1986-2001. The new service (only) gasket eliminates the need to attach the gasket to the block with a contact adhesive thus eliminating gasket creep (sideways) movement during installation. Slightly longer fasteners (bolts) have also been released and packaged in the kit. The old bolts must be replaced with the new on…