2000 Toyota Tacoma Power Steering Gear (4Wd And Pre Runner) Removal And Installation

REMOVAL NOTICE: Remove the steering wheel assembly before the steering gear removal, because there is possibility of breaking of the spiral cable. 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 2. REMOVE STEERING WHEEL PAD (See page SR–14) 3. REMOVE STEERING WHEEL (See page SR–14) 4. REMOVE ENGINE UNDER COVER Remove the 4 bolts and engine under cover. 5. DISCONNECT RH AND LH TIE ROD ENDS (See page SA–115) Download Related Entry: steering wheel rem…

2000 Toyota Tacoma Manual Transmission Assembly Removal And Installation

…ector (4WD). 5. REMOVE 2 RESTRICT PINS Torque: 37 N·m (380 kgf·cm, 27 ft·lbf) 1. Download Related Entry: toyota Tacoma transmission removal , removing a manual transmission in a 2003 toyota tacoma , removing manual trans from transaxel toyota tacoma , how to replace a tacoma transmission mount , how to remove a 2000 toyota tacoma truck transmishin , removal of an automatic transmission on 03 tacoma , remove 2003 tacoma transmission pan , how to…

2003 Toyota Tacoma Rear Differential Carrier Removal And Installation

…spider. Install the pinion gear with spider to the RH case. FA2049 (e) Using a dial indicator, measure the side gear backlash with holding the side gear and spider. Backlash: 0.05 – 0.20 mm (0.0020 – 0.0079 in.) HINT: S S Measure at all 4 locations. Measure the backlash at the RH case and the LH case. If the backlash is not within the specified value, install a thrust washer of a different thickness. Download Related Entry: TOYOTA TACOMA REAR D…

2005 Hyundai Elantra POWER STEERING GEAR AND LINKAGE ASSEMBLY REPLACEMENT PROCEDURE

…2005 MY Elantra (XD) and Tiburon (GK) vehicles may have been manufactured with threaded portions of the steering gearbox assembly’s left and right inner ball joint assemblies with internal cracks in the material structure. If the threaded portion of a steering gearbox assembly’s inner ball joint assembly was to break as a result of the internal crack, the tie rod end assembly would no longer be attached to the steering gear box. This would preven…

1996 Ford Taurus Power Strering Hoses Pressure and Return

Hose Fittings, Pressure and Return Line at Steering Gear and Pump The tube portion of the power steering hose assembly may disengage from the connector assembly for any of the following reasons: if not fully assembled. if snap ring is missing. if female port in power steering short rack (3L547), or oil pan flange reinforcement (6A674) is too shallow. if tube nut or power steering pressure hose (3A719) or power steering return hose (3A713) end is…