2004-2007 Chevrolet Malibu Fuel Tank Removal and Installation

Some customers may comment on the following conditions: • The fuel gauge does not rise above the 3/4 mark after a fill up or the fuel gauge appears “stuck”. • An illumination of the check engine light. • On rare occasions, the fuel gauge does not read the correct level which may result in a no start condition due to a low fuel level. Upon further investigation, the technician may find DTC P0455/P0461 Fuel Level Sensor Circuit…

Toyota RAV4 Fuel Tank Removal and Installation

1. REMOVE FUEL TANK ASSEMBLY (a) Remove the fuel tank (see page FU-39). 2. REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY (a) Remove the joint clip and fuel tank main tube. CAUTION: • Before removing the tube joint clip, check for foreign matter around the clip. Clean if necessary. • Keep the O-ring free of foreign matter, as it becomes contaminated easily. • Do not use any tools in this procedure. • Do not forcefully bend or twist the tube. • Put the…

2005 SCION tC Fuel Tank Removal and Installation

…tch to OFF after the engine stops. HINT: DTC P0171 (system to lean) may be present. (3) Crank the engine again and check that the engine does not start. (4) Remove the fuel tank cap, then discharge the pres- sure in the fuel tank completely. (d) Disconnect the wire to wire connector. 4. REMOVE FUEL SUCTION W/ PUMP & GAUGE TUBE ASSY (a) Disconnect the fuel tank main tube. (1) Remove the tube joint clip, then pull the fuel tube joint out of…

1995 Toyota Previa Fuel System Pressure Release Removal and Installation

…-SUPERCHARGED. * I – SYSTEM/COMPONENT TESTS – SUPERCHARGED. Removal 1) Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE under FUEL SYSTEM. Remove fuel tank filler cap to release any fuel pressure from fuel tank. 2) Fuel tank must be removed for access to fuel pump. Drain fuel tank. Disconnect electrical connector at fuel pump. 3) Disconnect fuel outlet line and fuel return hose from fuel pump mounting bracket. Remove fuel…

2007 Mazda MX-5 Miata Sport Interior Trim Removal and Installation

…he battery cover. 2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .) 3. Remove the following parts: 1. Console (See CONSOLE REMOVAL/INSTALLATION .) 2. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .) 3. Side wall (See SIDE WALL REMOVAL/INSTALLATION .) 4. Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION .) 5. Center panel unit (See CENTER PANEL UNIT REMOVAL/INSTALLATION .) 6. Lower panel (See…