2003-2004 Ford F-150 Rear Axle Differential Cover, Axle Shaft, Oil Seal, and Rear Wheel Bearing Removal and Installation

…the vehicle in NEUTRAL, position on a hoist. For additional information, refer to Section 100-00. 2. Remove the rear wheel and tire assembly. For additional information, refer to Section 204-00.3. Remove the parts in the order indicated in the following illustration and table.4. To install, reverse the removal procedure. 5. Fill the axle with the specified quantity of the specified lubricant. For additional information, refer to the Specificatio…

2001 – 2003 Highlander Right Rear Axle Squeak Noise Repair Procedure (4WD)

All page references are for the 2002 highlander repair manual. 1. Remove rear wheel. 2. Remove speed sensor rear rh (see page 32–46). 3. Remove rear drive shaft assembly rh (see page 30–43). 4. Remove strut rod assembly rear (see page 27–11). 5. Separate rear suspension arm assembly no.2 rh (see page 27–14). 6. Separate rear suspension arm assembly no.1 rh (see page 27–14) 7. Separate rear disc brake caliper assembly rh. A. Remove the 2 bolts an…

2000 Toyota Tacoma Rear Axle Shaft & Bearing Removal And Installation

…case. If replacing inner oil seal, using slide hammer, pull inner seal from end of axle housing. 5. If replacing bearing, press bearing from backing plate. Using dial indicator, check rear axle shaft and runout at center of rear axle shaft and at flange. Replace rear axle shaft if shaft runout exceeds .079″ (2.01 mm). 6. Using dial indicator, check flange runout at end of flange near wheel lug nut stud on rear axle shaft. Replace rear axle…

2002-2005 Ford Explorer Noise From Rear Wheel Hub Bearings Service

Service procedure caution suspension fasteners are critical. When replacing suspension fasteners use original equipment fasteners, or fasteners of equivalent quality and design. Do not install a replacement fastener of lesser quality or different design. Proper torque values must be observed during reassembly to ensure correct retention of all components. Make sure the fasteners are reinstalled in the same orientation as when removed. Caution do…

2003-2004 Ford Explorer Rear Axle Halfshafts, Bearings and Seals Removal and Installation

1. CAUTION: Do not loosen the rear axle wheel hub retainer until after the wheel and tire assembly are removed from the vehicle. Wheel bearing damage will occur if the wheel bearing is unloaded with the weight of the vehicle applied. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to Section 100-00. 2. Remove the rear wheel and tire assembly. For additional information, refer to Section 204-00. Download…