2008 Chevrolet HHR Oil Pan Removal and Installation

…ined in this program is different from the service procedure found in the appropriate service manual(s). Engine Oil Pan Drain Plug Thread Insert Loose or Damaged, Oil Leak (Inspect Insert and Install New Insert, If Necessary) Inspect the engine oil drain plug thread insert using the procedure below. 1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in SI. 2. Position the appropriate drain pan under the engine oil pan drai…

Chevrolet Camaro Oil Pon Removal

…placing gaskets, Check~ ing bolt torque, etc.) have been followed, oi! seepage may occur at the ioint where the oil pan side rail gas- ket rear pan gasket. Oil pan reinforcement package (Part No. 484083) fits all V8 engines and wil! correct oii seepage. Download Related Entry: 2007 toyota tacoma water pump replacement , scion xa transmission pan bolts , 2004 ford freestar oil leak , tourqe for 2006 scion tc transmission pan , oil pan leak on 2004…

2006-2008 Chevrolet HHR Water Leak Repair Instruction

…dure Important: You must follow every detailed instruction or misdiagnosis may occur. Water may be entering the vehicle in a number of areas. Technicians must complete the test in the sequence below. 1. Open the hood. 2. Remove the sill plate and the kick pad trim. 3. Pull the carpet and the barrier pad up and remove the rubber baffle plugs from both sides of the vehicle. Download Related Entry: 2006 chevy hhr water leak , hhrleaking water repair…

2000-2003 Ford Excursion HIGH PRESSURE OIL PUMP LEAK Remoaval and Installation

…er Duty, 2000-2003 Excursion, and 2000-2003 F650/750 vehicles equipped with a 7.3L Diesel engine may exhibit an oil leak at the high pressure oil pump outlet fittings and/or end plug (see Figure 1). The leak may appear to be a rear main crankshaft seal, oil pan gasket, or other engine oil leak due to the drain hole machined in the crankcase valley which allows any oil in the valley to run down the back of the engine. ACTION High pressure oil pump…

2006 Chevrolet HHR LS Engine Cooling Removal and Installation

1. Drain the cooling system. Refer to Draining and Filling Cooling System (Static Fill) or Draining and Filling Cooling System (GE 47716 Fill). IMPORTANT: A drain has been provided at the bottom of the water pump for engine block coolant drainage. 2. Drain the coolant from the engine block at the water pump drain. After the coolant has drained, tighten the drain bolt. 3. Lower the vehicle. Download…