2006-2007 Toyota RAV4 Steering Intermediate Shaft Noise Removal And Installation

Introduction Some customers may hear a clunk, pop, or knock-type noise when turning the steering wheel left or right. A new intermediate shaft has been developed to address this condition. Use the following repair procedure to remove and replace the steering intermediate shaft. Download Related Entry: toyota rav4 whining noise 2007 , 2006 rav4 transmission removal , 2007 toyota rav 4 2 4 humming noise at idle , 2008 toyota rav4 clunking sound w…

2005 Toyota Tacoma Rear Suspension Noise Removal And Installation

…ap type noise coming from the rear suspension when traveling over bumps or rough road surfaces. The squeak type noise may be caused by a rubbing condition between the rear suspension leaves. The slap type noise may be caused by contact between the overload spring and the first leaf of the spring assembly. Perform the repair procedures outlined in this TSB to address these concerns. Download Related Entry: toyota tacoma sound when turning off , 2…

1999 Toyota RAV4 Drive Axles Differentials, Axle Shafts & Drive Shafts — Rear Integral Housing Removal and Installation

…r to the wheels. Drive pinion preload is adjusted using collapsible spacer. Side bearing preload is adjusted using plate washers. Rear differential may be a Limited Slip Differential (LSD) or a conventional type rear differential. If equipped with LSD, manufacturer does not recommend disassembly of differential case. Download Related Entry: ring and pinion gear for 2002 tundra 2 wheel drive , looking for 2002 2 wheel drive tundra pinion and gear…

2006 Honda Ridgeline Rear Window Will Not Open or Close Removal and Intsllation

REPAIR PROCEDURE 1. Remove the rear seat back. • Refer to page 20-115 of the 2006 Ridgeline Service Manual, or • Online, enter keyword REAR SEAT, and select Rear Seat Removal/Installation from the list.NOTE: Put on gloves to protect your hands, and take care not to bend or scratch the trim or panels. 2. Remove the rear trim panel. • Remove the clips. • Detach the hooks from the C-pillar trim on both sides. • Use the appropriate KTC trim tool to…

2000 Toyota Tacoma Rear Axle Shaft & Bearing Removal And Installation

rear axle shaft if flange runout exceeds .004″ (0.10 mm). Download Related Entry: 2010 lacrosse service rear axle , 2005 rav4 front wheel drive replace shaft , 2007 toyota 4 runner rear bearing noise , 2007 toyota four runner rear bearing , replacing rear cv axle shafts on a 2005 rav 4 , 07 scion tc auto trans cv axle replacement , replacing intermediate front shaft 2003 dodge ram front differential , replacing a cv axle on a 2008 scion ,…