2003 Volvo S60 Timing Belt Removal and Installation

…and turn accessory belt tensioner clockwise to release tension and remove accessory drive belt. 3. Remove front timing belt cover. Raise and support vehicle. Remove right front wheel. Remove nut from fender liner cover. 4. Install upper timing belt cover. Turn crankshaft clockwise (as viewed from timing belt end of engine) to align timing marks on timing belt cover, crankshaft pulley and camshaft sprockets. See Fig. 1 . Turn crankshaft an additio…

2003 Hyundai Elantra GLS Timing Belt Removal and Installation

…e all drive belts and drive pulleys from crankshaft and water pump. Remove generator bolt, if necessary. Remove crankshaft pulley and water pump pulley. 2. Remove timing belt covers and gaskets, noting bolt lengths and locations. DO NOT rotate engine counterclockwise, as viewed from timing belt side of engine. Remove timing belt tensioner pulley. 3. Rotate engine clockwise to align all timing marks so No. 1 cylinder is at TDC of compression strok…

2005 SCION tC Timing Gear Case Or Timing Chain Case Oil Seal (2AZ–FE) Removal and Installation

…ONT FENDER APRON SEAL RH (See page 18–7) REMOVE FAN AND GENERATOR V BELT (See page 14–5) SST 09249–63010 REMOVE CRANKSHAFT PULLEY (See page 14–76) SST 09213–54015 (91651–60855), 09330–00021, 09950–50013 (09951–05010, 09952–05010, 09953–05020, 09954–05021) 4. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL (a) Using a knife, cut off the oil seal lip. (b) Using a screwdriver with its tip wrapped with tape, pry out the oil seal. NOTICE: After…

2004 Hyundai Accent Timing Belt Removal and Installation

…ssary. Loosen, but do not remove water pump pulley bolts. Remove all accessory drive belts. Remove pulleys from crankshaft and water pump. CAUTION: DO NOT rotate engine counterclockwise. If reusing timing belt, place reference mark on timing belt to indicate direction of rotation before removal. 2. Remove timing belt covers and gaskets, noting bolt length and location. Rotate crankshaft clockwise to align timing marks on crankshaft and camshaft s…

2000 Ford Expedition Timing Chains Removal and Installation

…onized. NOTE: Special tools required: Camshaft Holding Tool (303-557), Camshaft Positioning Tool (303-S568) and Crankshaft Holding Tool (303-448). See Fig. 8 Fig. 9 and Fig. 10 . Removal 1. Remove front cover. See FRONT COVER. Remove crankshaft position sensor pulse wheel from crankshaft. See Fig. 11. CAUTION: Unless otherwise instructed, at no time when the timing chains are removed and the cylinder heads are installed is the crankshaft or camsh…