2005 SCION tC Quarter Window Removal And Installation

REPLACEMENT HINT: S The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included. Use the same procedures for the LH side and RH side. A bolt without a torque specification is shown in the standard bolt chart (see page 03–2). REMOVE TONNEAU COVER ASSY REMOVE REAR SEAT CUSHION ASSY (See page 72–12) REMOVE REAR SEATBACK ASSY LH (See page 72–12) REMOVE R…

2005 SCION tC Rear Shock Absorber With Coil Spring Removal and Installation

Components: see page 27–2. 1. Remove tonneau cover assy (see page 76–27) 2. Remove deck board sub–assy (see page 76–27) 3. Remove back door scuff plate (see page 76–27) 4. Remove deck floor box lh (see page 76–27) 5. Remove deck floor box rh (see page 76–27) 6. Remove rope hook assy (see page 76–27) 7. Remove rear floor board no.1 (see page 76–27) 8. Remove rear seat cushion assy (see page 72–12) 9. Remove rear seatback assy lh (see page 72–12)…

2004-2005 Ford F-150 Window Glass — Rear Removal and Installation

Removal NOTE: If the rear window glass is being removed to repair a dust/water leak, remove and reinstall the existing rear window glass. All vehicles 1. For regular and SuperCab vehicles, remove the headliner. For SuperCrew vehicles, lower and position the headliner forward. For additional information, refer to Section 501-05. 2. Remove the rear trim panel pin-type retainers. 3. Remove the rear trim panel. Power sliding rear window 4. Remove th…

2005 Toyota Tacoma Rear Brake Removal And Installation

OVERHAUL HINT: The overhaul procedure for the RH side is the same as that for the LH side. 1. REMOVE REAR WHEEL 2. DRAIN BRAKE FLUID NOTICE: Immediately wash off any brake fluid that comes into contact with any painted surfaces. REMOVE REAR BRAKE DRUM SUB−ASSY Release the parking brake, and remove the rear brake drum. If the rear brake drum cannot be removed easily, perform the following procedures. (b) Remove the hole plug and insert a screwdri…

2000 Toyota Tacoma Rear Axle Shaft & Bearing Removal And Installation

olts. 4. On models not equipped with ABS, remove snap ring from rear axle shaft. Install backing plate-to-axle housing nuts. Using press, press rear axle shaft from backing plate. If replacing outer oil seal, use slide hammer to pull outer oil seal from bearing case. If replacing inner oil seal, using slide hammer, pull inner seal from end of axle housing. 5. If replacing bearing, press bearing from backing plate. Using dial indicator, check rear…