2000 Chevrolet S10 Blazer Oil Pump REMOVAL & INSTALLATION

1. Remove or disconnect the following: • Oil pan • Oil pump and the pickup tube/shaft, if equipped • Extension shaft and retainer fromthe pump, if necessary for the 2.2L engine ➦Be careful not to crack the retainer. To install: 2. Inspect the pins (oil pump locator) for damage, and replace the pins if required. To install: Download Related Entry: 2 2l s10 engine removal , 2000 blazer oil pump , 2000BLAZEROILPUMP , HOW TO INSTALL A OIL PUMP IN…

2000-2003 Ford Excursion HIGH PRESSURE OIL PUMP LEAK Remoaval and Installation

…fittings and/or end plug can be serviced without removing the pump assembly. Replace the O-rings on the fittings and the end plug using Kit 2C3Z-9G804-AA. All three (3) O-rings should be replaced. Apply liquid thread sealer (included in the kit) prior to reinstallation. Refer to the following Service Procedure for details. Download Related Entry: yhs-001 , where is the oilpump located on a 2008 chevy aveo 5 , replace oil pump 2000 s10 , leaking…

2004 Ford Excursion Oil Pump Removal and Installation

…y onto the oil pump drive and check the oil pump drive gear backlash. 7. Remove the bolts from the high-pressure oil pump discharge pipe. 8. Using the special tool, disconnect and remove the high-pressure oil pump discharge pipe. • Remove and discard the D-shaped O-ring seal. Download Related Entry: 2004 ford explorer oil pump location , 2004 ford explorer oil pump replacement , 2004 taurus oil pump replacment , how to change a oil [pump on a 20…

2004 Ford F-550 Oil Pump — Early Build Removal and Installation

Removal 1. Remove the intake manifold. For additional information, refer to Section 303-01C. 2. Remove the turbocharger adapter pipe. 3. Secure the turbocharger outlet pipe.4. Remove the turbocharger heat shield. 5. Remove the bolts and the high-pressure oil pump cover. • Use a thin gasket scraper to separate the cover from the crankcase. • Remove and discard the press-in-place gasket.6. Position the dial indicator with bracketry onto the oil pu…

1996 Bronco/F-Series Engine Front Cover Removal and Installation

…crankshaft damper spacer from crankshaft (6303). Download Related Entry: how to remove power steering pully on toyota rav4 , how to repair stering wheel mitsubishi diamante 2003 , how to replace vibration damper series 60 , instuctions air bag trailblazer ss , miata engine removal , mx5 grill removal , removal of head 06 scion , removing radiator 2008 rav4 , REPLACEMENT B PILLAR COVER 2006 F150 , toyota service manual on 07 Rav4 Water Pump Repl…