2005 SCION tC CYLINDER HEAD GASKET Removal and Installation

…remove hood sub–assy remove front wheel rh remove engine under cover rh remove engine under cover lh remove front fender apron seal rh (see page 18–7) remove engine cover sub–assy no.1 (see page 14–76) remove front wiper arm head cap (see page 66–6) remove fr wiper arm lh (see page 66–6) remove fr wiper arm rh (see page 66–6) remove hood to cowl top seal (see page 66–6) remove cowl top ventilator louver lh (see page 66–6) remove wiper link assy…

2004 SCION xB Cylinder Head Gasket Removal And Installation

REPLACEMENT 1. 2. DISCHARGE FUEL SYSTEM PRESSURE (See page 11–1) REMOVE CHAIN SUB–ASSY (See page 14–68) 3. (a) 4. (a) SEPARATE EXHAUST PIPE ASSY FRONT Remove the 2 bolts and 2 compression spring which are installed on the front side of the exhaust pipe. REMOVE EXHAUST MANIFOLD HEAT INSULATOR NO.1 Remove the 4 bolts and exhaust manifold heat insulator. A80954 5. (a) 6. 7. 8. 9. A79684 10. (a) (b) (c) (d) REMOVE MANIFOLD SUPPORT BRACKET Remove…

2000 Jaguar S-Type Cylinder Head Gasket Removal And Installation

1. Install a new cylinder head gasket to the cylinder block face. 2. Install the cylinder head. 3. Install the cylinder head bolts, do not fully tighten.Stage 1 – tighten bolts in sequence, to 20 Nm.5. Stage 2 – tighten bolts in sequence, to 35 Nm.6. Stage 3 – tighten bolts in sequence by 90° …

Continue reading ‘2000 Jaguar S-Type Cylinder Head Gasket Removal And Installation’ »

1988-1995 Toyota 4Runner Cylinder Head Removal and Installation

Procedure The Cylinder head bolts are tightened in three progressive steps: 1. Install cylinder head a. Place a new cylinder head gasket on the engine block and install cylinder head. b. Apply a light coat of engine oil on the threads and washer face of the cylinder head bolts. c. Install the plate washer to the cylinder head bolt. d. Using a 12–point socket, install and uniformly tighten the (8) 12–point bolts in several passes, in the…

1999-2003 Ford Expedition Cylinder Head Removal and Installation

SERVICE INFORMATION Cylinder heads damaged by brinnelling (depression marks from original gasket) of the head may still be re-usable. The revised “Service-Only” gasket has a feature by which the embossed sealing area does not follow the same sealing path as the original gasket. This area is surrounding the high pressure oil feed (HPOF) area. It is triangular in shape and is found in the rear of the passenger side cylinder head, or, in the front…