1997-1995 Ford Taurus Wiper/Washer Systems Removal And Installation

ISSUE Motoreraft remanufactured front wiper motors do not ìnciude the mounting bracket or depressed park ,output arm. The mounting bracket and depressed park output ann must be transferred from the oid wiper motor to the replacement wiper motor. Care must be taken to ensure proper orientation of the windlatch assembly and depressed park output arm. ACTION The front wiper motor mounting bracket and output arm must be removed from the old front wi…

1996 Ford Taurus Hub and Bearing Assembly Removal and Installation

CAUTION: Do not begin this removal procedure unless the following parts are available: A new wheel hub retainer and washer assembly (Step 1). A new inboard halfshaft joint stub shaft circlip. Once removed, these parts must not be reused during assembly. Their torque holding ability or retention capability is diminished during removal. Removal 1. Turn ignition switch to the OFF position and place the steering column in the unlock position. 2. Rem…

2007 Mazda MX-5 Miata Sport Wiper/Washer System Removal and Installation

1. Remove in the order indicated in Fig. 2.2. Install in the reverse order of removal. 3. Adjust the wiper arm and blade. (See WIPER ARM AND BLADE ADJUSTMENT .) WIPER ARM INSTALLATION NOTE 1. Clean the wiper arm connector shafts using a wire brush before installing the wiper arms.WIPER ARM AND BLADE ADJUSTMENT 1. Operate the wipers, and then turn off the wiper motor to set the wipers in the park position. 2. Slide the serrated connecting part an…

2004 Ford Taurus Wheel Knuckle Removal And Installation

…number must be used if installation is necessary. Do not use a new part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts. All vehicles 1. CAUTION: Discard the wheel hub retainer (3B477). It is a torque prevailing design and cannot be reused. If loosened, the retainer must be removed and a new one installed. NOTE: Make sure the steering wheel is in t…

Ford Taurus Rear Camber Bushing Installation Instructions

Check for loose or worn parts and replace if necessary. Jack up the rear of the car by the lower control arms. (Fig:1) 3. Remove the upper control arm bolt to knuckle. (Fig: 2) 4. Remove the rear toe arm bolt. (Fig: 3) 5. Remove and support the brake caliper. Note: There will be rear-ward pressure on the front lower control arm — proceed with caution. You may need to use a pry bar on the lower control arm to relieve the pressure (Fig: 4). 1. 2….