2000 Jaguar S-Type Timing Chain Removal And Installtion

50. Install the timing chain guide. Tighten to 12 Nm .51. Install the crankshaft sprocket.52. Install the chain tensioning tool 303-532 to the exhaust camshaft sprocket. Reposition the sprocket (and the VVT unit) for the most advantageous position for use of the tool. Remove the tool.53. Install the primary timing chain. Install the primary chain over the crankshaft sprocket and the WT unit sprocket. There must be no slack on the drive side of t…

1992 Mitsubishi Eclipse Timing Belt Removal & Installation

Removal CAUTION: To prevent engine damage, DO NOT rotate crankshaft counterclockwise (as viewed from timing belt end of engine). 1. Disconnect negative battery cable. Disconnect power steering hose clamp. Remove engine undercover. Place wooden block between jack and oil pan. Raise engine slightly. 2. Remove engine mount assembly near timing belt cover. Remove all drive belts and tensioner pulley bracket. See Fig. 1 . Remove power steering, water…

1998 Mitsubishi Galant ES Timing Belt & Balance Shaft Belt Removal and Installation

Removal (Eclipse & Galant) 1. Raise and support vehicle. Remove engine splash shield from right side wheelwell. 2. Lower vehicle. Support weight of engine with floor jack. If necessary, remove coolant reservoir. Remove upper engine mount located near timing belt cover. Remove all drive belts. If necessary, remove drive belt tensioner pulley bracket and power steering pump pulley. See Fig. 1 . Remove water pump pulley. 3. Remove crankshaft pu…

2000-2001 Jaguar S-Type Front Lower Ball Joints – Check Torque Removal and Installation

Issue: As a result of ongoing process assessments, Jaguar has identified a safety-related defect on a number of S-TYPE vehicles. On the vehicles involved, it is possible that an under-torque condition may exist on the front lower ball joint assembly. This may result in a high bending fatigue loading condition on the joint. In some cases the high bending loads could result in a fracture in the first thread of the ball stud that could then lead to…

2005 SCION tC Timing Gear Case Or Timing Chain Case Oil Seal (2AZ–FE) Removal and Installation

1. 2. 3. REMOVE FRONT WHEEL RH REMOVE FRONT FENDER APRON SEAL RH (See page 18–7) REMOVE FAN AND GENERATOR V BELT (See page 14–5) SST 09249–63010 REMOVE CRANKSHAFT PULLEY (See page 14–76) SST 09213–54015 (91651–60855), 09330–00021, 09950–50013 (09951–05010, 09952–05010, 09953–05020, 09954–05021) 4. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL (a) Using a knife, cut off the oil seal lip. (b) Using a screwdriver with its tip wrapped with t…