2001 – 2003 Highlander Right Rear Axle Squeak Noise Repair Procedure (4WD)

…sembly rh (see page 30–43). 4. Remove strut rod assembly rear (see page 27–11). 5. Separate rear suspension arm assembly no.2 rh (see page 27–14). 6. Separate rear suspension arm assembly no.1 rh (see page 27–14) 7. Separate rear disc brake caliper assembly rh. A. Remove the 2 bolts and brake caliper. B. Support the brake caliper securely. 8. Remove rear disc. 9. Remove parking brake shoe return tension spring (see page 33–17). 10. Remove…

2005 Toyota Tacoma Rear Brake Removal And Installation

…NT: The overhaul procedure for the RH side is the same as that for the LH side. 1. REMOVE REAR WHEEL 2. DRAIN BRAKE FLUID NOTICE: Immediately wash off any brake fluid that comes into contact with any painted surfaces. REMOVE REAR BRAKE DRUM SUB−ASSY Release the parking brake, and remove the rear brake drum. If the rear brake drum cannot be removed easily, perform the following procedures. (b) Remove the hole plug and insert a screwdriver through…

2005 Toyota Highlander Rear Door Repair Manual (RM1144U)

…b) remove the inside handle, and then disconnect the 2 cables from the rear door lock. 5. Remove rear door service hole cover lh 6. Remove rear speaker assy (a) remove the 3 bolts. (b) disconnect the connector and remove the rear speaker.7. Remove rear door belt moulding assy lh (see page 76-12 ) 8. Remove rear door glass run lh 9. Remove rear door window division bar sub-assy lh (a) remove the 2 bolts, screw and division bar. 10. Remove rear…

2004 SCION xB Rear Brake Removal And Installation

…0 mm (0.039 in.) If the thickness is less than the minimum, replace the shoes. 1. C97034 2. REMOVE REAR WHEEL 3. DRAIN BRAKE FLUID NOTICE: Wash the brake fluid off immediately if it adheres to any painted surfaces. 4. REMOVE REAR BRAKE DRUM SUB–ASSY (a) Release the parking brake lever, and remove the brake drum. HINT: If the brake drum cannot be removed easily, perform the follow- ing procedures. (b) Remove the hole plug and insert a screwdriver…

2000 Toyota Tacoma Rear Axle Shaft & Bearing Removal And Installation

Removal (Tacoma & 4Runner) 1. Raise and support vehicle. Remove rear wheel. Remove brake drum. Using a dial indicator, check axle shaft bearing side play and hub out of round. Maximum axle shaft bearing side play is .028″ (0.71 mm). Maximum hub axle shaft bearing out of round is .004″ (0.10 mm). Replace axle shaft bearing or axle shaft as necessary. 2. Remove ABS speed sensor (if equipped). Remove brake shoes from backing plate….