2005 Toyota Highlander Rear Door Repair Manual (RM1144U)

…ce hole cover lh 6. Remove rear speaker assy (a) remove the 3 bolts. (b) disconnect the connector and remove the rear speaker.7. Remove rear door belt moulding assy lh (see page 76-12 ) 8. Remove rear door glass run lh 9. Remove rear door window division bar sub-assy lh (a) remove the 2 bolts, screw and division bar. 10. Remove rear door quarter window glass lh 11. Remove rear door glass sub-assy lh hint: insert a shop rag inside the door panel t…

2001 Ford Expedition Wheel Hub and Bearing Removal and Installation

Removal 1. Raise and support the vehicle. For additional information, refer to Section 100-02. 2. CAUTION: Do not use heat to loosen a seized wheel nut. Heat can damage the wheel and the wheel bearings. Remove the tire and wheel assembly. For additional information, refer to Section 204-04. 3. Remove the front disc brake caliper and anchor plate. For additional information, refer to Section 206-03. 4. Remove the hub grease cap (1131), cotter pin…

2003-2004 Ford F-150 Rear Axle Differential Cover, Axle Shaft, Oil Seal, and Rear Wheel Bearing Removal and Installation

1. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to Section 100-00. 2. Remove the rear wheel and tire assembly. For additional information, refer to Section 204-00.3. Remove the parts in the order indicated in the following illustration and table.4. To install, reverse the removal procedure. 5. Fill the axle with the specified quantity of the specified lubricant. For additional information, refer to the Spec…

2005 SCION tC Front Wheel Alignment Removal And Installation

1. INSPECT TIRE (SEE PAGE 28–1) 2. MEASURE VEHICLE HEIGHT Vehicle height: Front A – B 92 mm (3.62 in.) Rear D – C 63 mm (2.48 in.) B A C Measuring points: A: Ground clearance of front wheel center B: Ground clearance of lower suspension arm front bolt center C: Ground clearance of tie rod set bolt center D: Ground clearance of rear wheel center NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value. HINT:…

1997 Ford F-250 Axle Shaft, Hub, Oil Seal and Outer Wheel Bearing Removal and Installation

Removal NOTE: If, for any reason, the rear hub (1109) is removed from the spindle, the old hub seal must be removed and a new hub seal installed. 1. Set the parking brake and loosen the eight axle shaft retaining bolts. 2. Raise the vehicle to the desired working height, keeping the axle parallel with the floor. 3. Release parking brake and back off the rear brake adjustment, if necessary. 4. Remove the wheel (1007). 5. Remove brake drum (1126)….