2003-2004 Ford F-150 Rear Axle Differential Cover, Axle Shaft, Oil Seal, and Rear Wheel Bearing Removal and Installation

…ant. For additional information, refer to the Specifications in this section. Download Related Entry: complete rear diff 2004 explorer , how to replace rear lug bolts 2004 ford expedition , changing rear axle seal on 2004 rav4 , install suzuki forenza axle shaft , how to remove hub from back axle 2003 ford explorer 4×4 , front axle seal drivers side 2007 ford explorer , 02 explorer differential clutch pack installation , 2004 explorer replace d…

2005 SCION tC Front Wheel Alignment Removal And Installation

1. INSPECT TIRE (SEE PAGE 28–1) 2. MEASURE VEHICLE HEIGHT Vehicle height: Front A – B 92 mm (3.62 in.) Rear D – C 63 mm (2.48 in.) B A C Measuring points: A: Ground clearance of front wheel center B: Ground clearance of lower suspension arm front bolt center C: Ground clearance of tie rod set bolt center D: Ground clearance of rear wheel center NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value. HINT:…

1997 Ford F-250 Axle Shaft, Hub, Oil Seal and Outer Wheel Bearing Removal and Installation

Removal NOTE: If, for any reason, the rear hub (1109) is removed from the spindle, the old hub seal must be removed and a new hub seal installed. 1. Set the parking brake and loosen the eight axle shaft retaining bolts. 2. Raise the vehicle to the desired working height, keeping the axle parallel with the floor. 3. Release parking brake and back off the rear brake adjustment, if necessary. 4. Remove the wheel (1007). 5. Remove brake drum (1126)….

1994-1997 Ford Explorer Oil Pan Removal and Installation

…ove the oil pan and crankshaft oil windage baffle . 3. Rotate the engine upside down and remove the oil pump and rear main bearing cap and wedge seal. 4. Remove and discard the crankshaft rear main seal. Installation CAUTION: Prevent engine assembly contamination. Always use necessary precautions to prevent old sealer or gasket material from falling into the engine . 1. Thoroughly clean ALL the oil and the old sealer from the oil pan taking speci…

2005 Toyota Tacoma Rear Brake Removal And Installation

OVERHAUL HINT: The overhaul procedure for the RH side is the same as that for the LH side. 1. REMOVE REAR WHEEL 2. DRAIN BRAKE FLUID NOTICE: Immediately wash off any brake fluid that comes into contact with any painted surfaces. REMOVE REAR BRAKE DRUM SUB−ASSY Release the parking brake, and remove the rear brake drum. If the rear brake drum cannot be removed easily, perform the following procedures. (b) Remove the hole plug and insert a screwdri…