1988-1995 Toyota 4Runner Cylinder Head Removal and Installation

…ead bolt. d. Using a 12–point socket, install and uniformly tighten the (8) 12–point bolts in several passes, in the sequence shown in the illustration. Download Related Entry: yhs-002 , how to instal fog light to rav 4 2014 , 1988 toyota 4 runner 6 cylinder air intake manifold removal , rav4 head removal 2 4 , how to remove cylinder head on a 2003 toyota rav 4 , toyota 4runner head bolt sequince , how to instal fog light rav 4 2014 , gasket he…

2005 SCION tC CYLINDER HEAD GASKET Removal and Installation

…e page 10–12) remove fuel delivery pipe sub–assy (see page 11–14) sst 09268–21010 Download Related Entry: pull head on 2005 scion , 2006 scion 2 4 cylinder head tighening procedure , 2010 scion front hub bearing remover , a head for a 2005 sion xb 1 5 , head removal 2003 2 4 eclipse , how to change gasket scion tc 2007 , procedures to remove front wheel bearing 2008 scion tc , steps to replaced a head gasket o a 06 scion xb , Toyota scion tc re…

2004 SCION xB Cylinder Head Gasket Removal And Installation

REPLACEMENT 1. 2. DISCHARGE FUEL SYSTEM PRESSURE (See page 11–1) REMOVE CHAIN SUB–ASSY (See page 14–68) 3. (a) 4. (a) SEPARATE EXHAUST PIPE ASSY FRONT Remove the 2 bolts and 2 compression spring which are installed on the front side of the exhaust pipe. REMOVE EXHAUST MANIFOLD HEAT INSULATOR NO.1 Remove the 4 bolts and exhaust manifold heat insulator. A80954 5. (a) 6. 7. 8. 9. A79684 10. (a) (b) (c) (d) REMOVE MANIFOLD SUPPORT BRACKET Remove the

2000 Jaguar S-Type Cylinder Head Gasket Removal And Installation

1. Install a new cylinder head gasket to the cylinder block face. 2. Install the cylinder head. 3. Install the cylinder head bolts, do not fully tighten.Stage 1 – tighten bolts in sequence, to 20 Nm.5. Stage 2 – tighten bolts in sequence, to 35 Nm.6. Stage 3 – tighten bolts in sequence by 90° .7. Stage 4 – tighten all M10 bolts in sequence by 90° . Download Related Entry: how to replace head gasket on a4 0 2000 jaguar ,…

1997 Toyota Supra Valve Clearance Inspection

Inspect and adjust the valve clearance when the engine is cold. 1. REMOVE THROTTLE BODY AND INTAKE AIR CON- NECTOR ASSEMBLY (See page SF-19 ) 2. DISCONNECT HIGH-TENSION CODES (See page IG-8 ) 3. REMOVE NO.3, NO.1 AND NO.2 CYLINDER HEAD COVERS Remove the 4 bolts, 4 nuts and No.3 cylinder head cover. Remove the 4 bolts, No.1 cylinder head cover and gasket. Remove the 4 bolts, No.2 cylinder head cover and gasket. Download…