1997 Ford Aerostar, Ford Ranger Shift Lever Removal and Installation

NOTE: Remove the gearshift lever knob (7213) only if the knob, gearshift lever boot (7277) or gearshift lever (7210) is to be replaced. Removal 1. Shift transfer case (7A195) into the 4L position. 2. Remove the plastic shift pattern insert from the gearshift lever knob. Warm the knob with Rotunda Heat Gun 107-R0300 or equivalent …

Continue reading ‘1997 Ford Aerostar, Ford Ranger Shift Lever Removal and Installation’ »

1997 Ford Aerostar, Ford Ranger Transfer Case Removal and Installation

CAUTION: The three way catalytic converter (TWC) (5E212) is located beside the transfer case (7A195). Be careful when working around the three way catalytic converter because of the extremely high temperatures generated by the three way catalytic converter. Removal 1. Raise the vehicle on a hoist and position suitable safety stands under vehicle. 2. If …

Continue reading ‘1997 Ford Aerostar, Ford Ranger Transfer Case Removal and Installation’ »

Cadillac CTS-V Short Shifter Removal and Installation

Remove the shift knob and leather boot From within the car: the knob is attached to the boot, so it will not come off completely but must be separated from the shift lever. Pull the knob straight up (do not twist), and then lift up on the shift boot, prying it off the console with …

Continue reading ‘Cadillac CTS-V Short Shifter Removal and Installation’ »

2003 Toyota Tacoma Automatic Transmission Unit Removal And Installation

REMOVAL 1. 2. REMOVE ATF LEVEL GAUGE REMOVE ENGINE UNDER COVER Torque: 29 N·m (296 kgf·cm, 21 ft·lbf) 3. (a) (b) 3RZ–FE: DISCONNECT THROTTLE CABLE Loosen the nut and disconnect the cable. Separate the throttle cable from the clamp. Q07485 4. REMOVE NO.1 FAN SHROUD Remove the 4 bolts and No.1 fan shroud. P20923 5. …

Continue reading ‘2003 Toyota Tacoma Automatic Transmission Unit Removal And Installation’ »

1989 Toyota 4Runner Transmission Removal & Installation – M/T

REMOVAL & INSTALLATION Removal 1) Disconnect battery cable. Remove air cleaner. Drain cooling system. Remove upper radiator hose. On Land Cruiser, remove cowl side trim, heater duct on transmission hump and front carpet or mat. On all models, remove shift lever boot, shifter assembly and starter. On Land Cruiser, remove transfer case levers. 2) Raise …

Continue reading ‘1989 Toyota 4Runner Transmission Removal & Installation – M/T’ »